Description:
DuPont Imron® Industrial Strength is the next generation of Imron® technology. Based upon patented DuPont formulations and resin technology, Imron® Industrial Strength is the fastest Imron® yet, providing the “Wet Look that Lasts” with the lowest environmental impact. Imron® Industrial Strength Ultra Low VOC Polyurethane Clear 9C01™ is a high gloss, 0.3 lbs/gal VOC* conforming, low HAPS, polyurethane clear coat. The resulting finish product provides a brush, roll or sprayable topcoat suitable for use in any environment where additional long term color and gloss retention are desired - See section on VOC (page 2).
Suggested Uses: As a high performance, tough, industrial strength polyurethane clear coat over properly prepared, primed and top-coated aluminum, carbon steel, galvanized, concrete or dry wall where:
Not recommended for: Immersion service
COMPATIBILITY WITH OTHER COATINGS
Contact your DuPont Performance Coatings representative for specific recommendations.
MAXIMUM SERVICE TEMPERATURE
250ºF (93ºC) in continuous service. 300ºF (148ºC) in intermittent heat.
PERFORMANCE PROPERTIES
VOC (Theoretical less water and exempt compounds).
This product contains TBAc.
4 to 1 25% Reduction 4 to 1 25% Reduction TBAc Exempt* TBAc Non-Exempt No Reduction 9M01™ 9M02™ No Reduction 9M01™ 9M02™
Without 1 oz VG-805™ 0.3 -- -- 2.3 -- -- With 1 oz VG-805™ -- 0.4 1.0 -- 2.4 2.9
*Where TBAc is considered an exempt solvent for contains requirements.
HAPS Information – Theoretical
Imron® Industrial Strength Clear – Mixed 4 to 1 no reduction – 0.01 lbs/gal solids Imron® Industrial Strength Clear – Mixed 4 to 1 with 25% Imron® 9M01™ or 9M02™ Thinner and 1 oz. VG-805™ Accelerator – 0.01 lbs/gal solids
Gloss Weight Solids Volume Solids 90+ 60º angle 57% 56%
Theoretical Coverage Per Gallon 881 ft2 (21.5 m2/l) @ 1 mil dft 441 ft2 (10.8 m2/l) @ 2 mil dft Material losses during mixing and application will vary and must be taken into consideration when estimating job requirements.
Suggested Film Builds 3-5 mils (75-125 μm) wet 2-3 mils (50 – 75 μm) dry Application by brush and roller may require additional coats to achieve recommended films thickness.
Weight per gallon – Average varies with color 9.2 lbs
ASTM INFORMATION Physical properties are average. Properties listed are for a system of Corlar® LV SG™ (formerly 90P), DuPont Imron® Industrial Strength and Imron® Industrial Strength Clear. Total DFT 9 mils.
All technical advice, recommendations and services are rendered by the Seller gratis. They are based on technical data which the Seller believes to be reliable, and are intended for professional use by persons having skill and know-how at their own discretion and risk. Seller assumes no responsibility for results obtained or damages incurred from their use by Buyer in whole or in part. Such recommendations, technical advice or services are not to be taken as a license to operate under or intended to suggest infringement of any existing patent.
E-R5191 / K-20434
(7.09) © Copyright 2009. All rights reserved. The DuPont Oval, DuPont™, The miracles of science™ and Imron® are registered trademarks or trademarks of DuPont or its affiliates. All other names mentioned herein are the property of their respective owners.